YoungMedic
Well-Known Member
A while back I bookmarked a torso stand to purchase and sat on it for a bit, I just had a hard time dropping 60 + dollars on something I thought I could make so I set out to try and made a simple display stand with scrap wood and new plumbing parts cost in total was under 20 bucks and about 30 min of time
Parts : 2x4 at least back length of the jacket you intend to display, 1 45 degree 1.5 inch elbow, 24" 1.5 inch pipe, 1 inch pipe insulation, scrap ply wood, screws and a miter saw or miter box and saw.
Parts : 2x4 at least back length of the jacket you intend to display, 1 45 degree 1.5 inch elbow, 24" 1.5 inch pipe, 1 inch pipe insulation, scrap ply wood, screws and a miter saw or miter box and saw.